Posts Tagged freezing mortar
I often get asked this time of year, “How late in the construction season can we work with lime-sand mortars?” Well the quick and fast answer is 45 days before the first hard frost. Which means you should have your projects wrapping up by the end of October at the latest just to be safe. The reason for this safe period (as suggested by lime mortar manufacturers) is because of the way lime-sand mortars initially cure, by carbonation – absorbing CO2 back into the material through wetting and drying cycles. Most specifications call for a minimum of nine (9) wetting and drying cycles of misting the walls down with generous amounts of water after installation and allowing them to dry out naturally – drawing in the CO2 from the evaporation of the water. Obviously, this wet-curing process can become problematic during freezing temperatures.
The Brick Industry Association, March 1992, Technical Note 1 states, “Mortar which freezes is not as weather-resistant or as watertight as a mortar that has not been frozen. Furthermore, significant reductions in compressive and bond strength may occur. Mortar having a water content over 6 to 8 percent of the total volume will experience disruptive expansive forces if frozen due to the increase in volume of water when it is converted to ice. Thus, the bond between the unit and the mortar may be damaged or destroyed.”
But what if your schedule backs you up against old man winter and you have no choice but to work into November? Don’t lose heart. We carried out some testing 8 years ago on a project in Chicago [Lime Mortars, Two Recent Case Studies, Ed A. Gerns and Joshua Freedland] to find out how late in the season you could repoint a building using lime-sand mortars. Trials were conducted at various times in the fall and early winter at approximately six week intervals. The last installation occurred 48 hours before the first frost on November 23, 2003. Observations during installation, following initial curing, and periodically through the winter and following year were noted. The high-calcium lime putty and sand mortar showed no signs of shrinkage cracks, the bond between the mortar and brick units was well-adhered, and no erosion or cyclic freeze-thaw damage was observed. We were working with butter joint brickwork of 1/8 inch mortar joints.
To supplement the insitu testing, limited concurrent laboratory testing was conducted to evaluate the depth of carbonation and the impact of freezing temperatures had on the depth and rate of carbonation of the lime. Two inch mortar cubes were made from the same mortar formulation (1:2.5) – no additional water was added. The mortar cubes (eight sets) each went under freezing temperatures once for a four-hour duration at various times after initial mixing. The exposure to freezing temperatures (10F) was established at 24 hrs; 48hrs; 72hrs; 96hrs; 1 week and 2 weeks. The mortar cubes were then broken at various times and the depth of carbonation was measured using a phenolthalein solution as an indicator.
After 2 weeks, the depth of carbonation suggested that mortar cubes that were exposed to a freezing temperature for a limited duration during the first week had less depth of carbonation than the cubes that did not experience any freezing temperatures. After three weeks, however, this difference was no longer observable. All mortar cubes seemed to equalize after three weeks. Interesting. The success of this trial may be a result of the forgiving nature of lime-sand mortars, the low water content of the repointing mortar, and the narrow joint width of this particular project.
This paper was presented at the 2005 International Building Lime Symposium in Orlando, Florida. Proceedings are available on CD (ISBN 0-9767621-0-2). The CD includes 39 papers by authors from 10 countries. Also, included are several important historical documents related to building lime–some as old as 1920.
The conference proceedings are available for $25 at: http://www.lime.org/documents/publications/free_downloads/summary-ibls-2005.pdf