Posts Tagged hard cement mortars
The new term on the streets used by industry consultants to describe the details of how a building takes on water and then (hopefully) sheds it is “water management.” The longevity of historic masonry walls relies heavily on how water is managed in and around them. I am personally not yet convinced we can control water. I can work to manage where it goes, and possibly how long it stays – by redirecting it, but in the end it goes where it wants, the easiest way. When you attempt to fight water it usually wins. The ways water impacts a building depends on how long it stays – which is directly correlated to its architectural design, geographic location, topography, soil, the water table, the type of brick, stone or mortar, and whether the building has recently been restored.
Sometimes the understanding of historic load-bearing masonry walls built with lime mortar materials is not established, or respected, prior to a restoration project being undertaken. While the joints may look like they are in need of repointing due to deterioration, it’s important to know why they deteriorated in the first place. The cause is most likely from water saturation – then freezing and thawing or extreme temperature variations. One of the challenges is understanding that a building can, and does, breathe though its mortar joints as well as its masonry units.
The shear thickness of most load-bearing masonry walls keep the water out. The original building materials made for quick evaporation of the water on the surface of the walls and kept the inside dry, but this breathability does takes its toll on old lime mortar joints and they need to be repointed in high moisture areas every 75 to 100 years or so. Problems start when an architect specifies a replacement mortar that is harder than the original (in an effort to make it last longer) than potentially traps moisture inside the wall system. The effort in the restoration repairs is totally focused on keeping water out from coming in through the exterior side of the wall. The problem is that old masonry walls contain a certain amount of moisture already and often do not perform very well with harder/stronger mortar joints surrounding them.
When the goal of the restoration project is to create a Watertight Envelope you’d better run the other way – fast. “Watertight Envelope” and “Historic Load-bearing Masonry” should not be used in the same sentence. Keeping water on the outside would seem to be an honorable goal for any restoration project, but observing the current condition of some masonry buildings restored in the past 10 years tells us a much different story, a troubling one. Basically, the buildings subjected to this watertight-envelope theory are not doing very well.
Where waterproofing and harder cement-based mortars are applied we find decay patterns that are surprising – in just a decade after application. Instead of the mortar surfaces wearing, there is a new pattern of brick and stone decay. Strong osmotic and hydrostatic pressures build up in brick and stone that are subjected to these hard, strong, and water resistant materials.
Tomorrow we will discuss how water enters a building.